Metal Building Insulation in Bixby, OK

Quick facts	Answer
Cost range	$1.00-$4.50 per square foot installed; $3,500-$16,500 for many projects
Time	Spray foam on a 40x60 building takes about 2-3 days
Who's qualified	Ask the pro for proof of insurance and any license your state or city requires.

Bixby, OK: what's different here

Bixby sits in Tulsa County, about 18 miles and roughly 29 minutes by car from Tulsa via the main highway. The area has a hot-summer humid subtropical climate, so summer heat and humidity make insulation and condensation control practical concerns for metal buildings. Spray foam work should be scheduled after the shell is closed in and all roof and wall work is finished.

What does spray foam cost per square foot in Bixby?

Closed-cell spray foam for metal buildings is often priced around $3 to $5 per square foot at 2 inches. Open-cell foam is cheaper per square foot but usually needs a separate vapor barrier. By board foot, closed-cell runs about $1.00 to $2.12 and open-cell about $0.44 to $0.73 installed.

Is closed-cell spray foam good for metal building condensation?

Closed-cell spray foam at 2 inches provides about R-12 or more, plus an air barrier and a Class II vapor retarder. That matters in Bixby's humid subtropical climate, where condensation is a common moisture risk in metal buildings. The foam also bonds directly to metal purlins and girts, closing air gaps that batt or rigid board can leave.

How long does metal building insulation take to install?

A small crew can insulate a typical 40x60 metal building with batt insulation in about 1 to 2 days. Spray foam commonly takes 2 to 3 days. Re-entry time is commonly 24 hours or more depending on the foam manufacturer.

What R-value do open-cell and closed-cell foam provide?

Open-cell spray foam is typically around R-3.5 to R-3.7 per inch. Closed-cell spray foam is about R-6 to R-7 per inch. Closed-cell is usually the pick for metal buildings because it adds a vapor retarder along with insulation value.

What to do next

Measure your building's wall and roof square footage so the quote can be priced per square foot.
Ask whether the quote includes a vapor barrier or relies on closed-cell foam's built-in Class II vapor retarder.
Confirm the installer plans surface prep: metal must be clean and dry, with application temperatures between 50°F and 90°F.
Ask how the installer will meet the 2021 International Building Code thermal barrier requirement for foam plastic.
Call (918) 727-7715 or email [email protected] for a free quote from an independent, insured spray foam insulation contractor.

Tulsa Foam Pros is a free referral service: an independent contractor does the work and may pay us a referral fee. You never pay us anything.

Quick answers

How much does it cost to insulate a 2,000-square-foot metal shop in Bixby?

A typical 2,000-square-foot metal shop may cost about $7,000 to $12,000 to insulate. The price depends on R-value goals, climate, and whether vapor or air barriers are included.

When should spray foam be installed on a metal building?

Spray foam should be installed after the shell is closed in and all roof and wall work is finished. Metal surfaces should be clean and dry before application.

What building codes apply in Bixby, OK?

The Oklahoma Uniform Building Code Commission uses the 2021 International Energy Conservation Code with Oklahoma-specific amendments. Those statewide codes became effective November 13, 2022. The 2021 International Building Code also requires foam plastic to be separated from the interior by an approved thermal barrier.

Do I need a vapor barrier with open-cell foam on a metal building?

Yes, open-cell foam usually needs a separate vapor barrier. Closed-cell foam at 2 inches includes a Class II vapor retarder along with an air barrier.